LOGIN Code and ESP ECU coding service for G85 7D0959654

The ABS ESP ECU must always be recoded after installation!
For the coding you need the vehicle-specific 5-digit LOGIN and ECU code!
The basic setting for ESP sensor G85 must be carried out!
The fault memory in the ABS ESP ECU must then be deleted!

Caution!
After the repair, the ESP sensor G85 is reset by software and in
the basic position is fixed together with the airbag slip ring.

The ABS ESP ECU must always be recoded after installation.
The fault memory in the ABS ESP ECU is deleted and the basic setting
for G85!

The basic setting must be carried out after each exchange!
Steering angle sensor G85 must be installed in the middle position, steering wheel and wheels straight ahead!

Basic setting ESP steering angle sensor G85 with VCDS or VAS diagnosis device:

1. Connect the diagnostic device, switch on the ignition
2. Select address word 03 for ABS ESP.
3. Function 02 - read fault memory, then function 05 - delete fault memory
4. Function 08 measured value block and display group 005
Read measured value 01 for (G85), setpoint 0.0 tolerance -2.5 .. + 2.5
5. Enter function 11 LogIn procedure access authorization code "40168"
6. Enter function 04 basic setting and display group 001 and confirm.
7. End function 06 diagnosis
8. Start ESP system test and drive approx. 1-3 km left, right and straight ahead with the vehicle
until all ESP and ABS control lights have gone out.

We also request programming & coding service for ESP ECU and LWS G85.

Pin assignment of steering angle sensor G85:
1 = terminal 31
2 = CAN low
3 = CAN high
4 = terminal 30
5 = terminal 15
6 = not connect