Repair-Kit esp steering angle sensor slip ring 7D0959654 G85 VW BUS T4 7D

Repair Kit for ESP steering angle sensor G85
with partnumber 7D0959654 / 7D0 959 654

Installed in:
VW BUS T4 7D 1999 - 2003 with ESP System

Original spare part for repairing the slip ring with G85

- in the event of error 00778 steering angle sensor G85 008 - implausible signal
- in the event of error 00778 steering angle sensor G85 012 - no signal / communication
- with error 00778 steering angle sensor G85 - no basic setting
- with error 00778 steering angle sensor G85 - defective
- if the conductor tracks are damaged
- if the processor is defective or if there is a short circuit
- in the event of water damage


Repair Kit:
1x Board conector 6 pin
1x Install Info

Repair Kit is refurbished and  100% passed for Steering angle sensor G85
Article is refurbished and with 1 year guarantee!



Attention!

After the repair, the ESP sensor G85 is reset via software and in
the basic position is fixed together with the airbag slip ring!

The ABS ESP ECU must always be recoded after installation!
For the coding you need the vehicle-specific 5-digit LOGIN code and ECU code!
The basic setting for ESP sensor G85 must be carried out!
The fault memory in the ABS ESP ECU must then be deleted!

Please click here for LOGIN Code and ECU CODE Service.


The basic setting must be carried out after each exchange!
Steering angle sensor G85 must be installed in the middle position, steering wheel and wheels straight ahead!

Basic setting ESP steering angle sensor G85 with VCDS or VAS diagnosis device:

1. Connect the diagnostic device, switch on the ignition
2. Select address word 03 for ABS ESP.
3. Function 02 - read fault memory, then function 05 - delete fault memory
4. Function 08 measured value block and display group 005
Read measured value 01 for (G85), setpoint 0.0 tolerance -2.5 .. + 2.5
5. Enter function 11 LogIn procedure access authorization code "40168"
6. Enter function 04 basic setting and display group 001 and confirm.
7. End function 06 diagnosis
8. Start ESP system test and drive approx. 1-3 km left, right and straight ahead with the vehicle
until all ESP and ABS control lights have gone out.

We also request programming & coding service for ESP ECU and LWS G85.

Pin assignment of steering angle sensor G85:
1 = terminal 31
2 = CAN low
3 = CAN high
4 = terminal 30
5 = terminal 15
6 = not connect