Repair service esp steering angle sensor airbag slip ring 7D0959654 G85 VW BUS T4

Repair service of your defective ESP steering angle sensor G85 7D0959654 / 7D0 959 654
Repair-service of your sensor G85 with 12 months warranty


Possible errors in the ESP system:
- 00778 - 000 Steering angle sensor G85 defective
- 00778 - 003 Steering angle sensor G85 no signal
- 00778 - 008 Steering angle sensor G85 implausible signal
- 00778 - 012 Steering angle sensor G85 electrical circuit fault
- 00778 - 020 Steering angle sensor - G85 basic setting fault
- 00778 - 037 Steering angle sensor G85 defective
- 00778 - 049 Steering angle sensor G85 no communication
- 030A - Steering angle sensor (G85) defective
- 01044 / 0414 - ESP control unit incorrectly coded / not coded
- 18036 / 4674 - Drive data bus missing message from steering angle sensor G85
- P1628 - Drive data bus Missing signal from steering angle sensor G85

- ESP light illuminated / ESP inoperative
- Steering angle sensor G85 basic setting not possible
- ESP control unit cannot be coded
- ESP slip ring damaged by short circuit
- ESP slip ring damaged by water damage
- ESP slip ring severely worn


Installed in:
VW BUS T4 7D 1999 - 2003 with ESP System

Partnumber VW              7D0959654
Partnumber VW              7D0 959 654
Connector                       6 pin
Specialist designation     G85
Manufacturer ATW          Safety and product information



Procedure Repair-Service:
1. You buy this repair offer and pay via PayPal or bank transfer.
2. You send your defective ESP sensor G85 to my address.
3. We will repair your sensor G85 the 2 to 5 days.
4. Then we send the repaired ESP sensor G85 back to you the fastest way.


Attention!

After the repair, the ESP sensor G85 is reset via software and in
the basic position is fixed together with the airbag slip ring!

The ABS ESP ECU must always be recoded after installation!
For the coding you need the vehicle-specific 5-digit LOGIN and ECU code!
The basic setting for ESP sensor G85 must be carried out!
The fault memory in the ABS ESP ECU must then be deleted!

Please click here for LOGIN Code and ECU CODE Service.


The basic setting must be carried out after each exchange!
Steering angle sensor G85 must be installed in the middle position, steering wheel and wheels straight ahead!

Basic setting calibrate ESP steering angle sensor G85 with VCDS or VAS diagnosis device:

1. Connect the diagnostic device, switch on the ignition
2. Select address word 03 for ABS ESP.
3. Function 02 - read fault memory, then function 05 - delete fault memory
4. Function 08 measured value block and display group 005
Read measured value 01 for (G85), setpoint 0.0 tolerance -2.5 .. + 2.5
5. Enter function 11 LogIn procedure access authorization code "40168"
6. Enter function 04 basic setting and display group 001 and confirm.
7. End function 06 diagnosis
8. Start ESP system test and drive approx. 1-3 km left, right and straight ahead with the vehicle
until all ESP and ABS control lights have gone out.

We also request programming & coding service for ESP ECU and LWS G85.


Pin assignment of steering angle sensor G85:
1 = terminal 31
2 = CAN low
3 = CAN high
4 = terminal 30
5 = terminal 15
6 = not connect